Rv Awning Motor Maintenance

You may have to rotate the motor slightly to get the gears to line up and then rotate it back in place to line up the bolt holes.

Rv awning motor maintenance.

By doing this the motor should start to operate and extend or retract the awning. This told me the motor and wiring to the awning was good. I generally clean it every few months by following the procedure outlined in the owner s manual. Our large 21 foot dometic 9100 rv power awning is made out of vinyl and has held up very well after 4 years of full time rving.

Always let the awning air dry don t use heaters. One way to repair a motorized awning is to simply lubricate the working parts with some machine oil. To wash your rv awning simply hose it off. Solera awning motor wires remove the 3 bolts that hold the motor in place using a 10mm wrench or socket.

If the awning is not appropriately set the chances of getting new tears and holes will increase significantly. You yourself can replace most parts of the awning apart from few things like fabric and awning arms. Step 3 fix warped rails. Rub down the rails pulley rollers and retracting arm to make sure they are not sticking due to friction rust or dirt.

There is no purpose to take them out unless you want to replace the awning. This will work for both acrylic and vinyl awnings. Protect your rv awning from the damaging effects of uv radiation. I tried the awning using it and it worked.

Electric rv awning operation is simple enough and easy to maintain. Inspect pull strap slide pins rv awning motor if its electric awning. Ultraviolet rays from the sun will also take their toll on your awning. There can be several reasons for that and a repair man should be able to check on that.

Don t remove end caps. If that does not happen then the motor has gone bad. Keep the water temperature less than 100 degrees fahrenheit. Repairing the rv awning power switch.

While you are attaching your awning make sure not to take the end caps out. Remove the bad motor and replace it with the new one. I disassembled the control panel and swapped the slide out room switch it uses the same switch with the power awning switch and the fault swapped as well. The manual advises using a mixture of cup bleach cup dishwashing liquid added to 5 gallons of water.

Tips to maintain your rv awning.